|
|
6E1–119 RODEO X22SE 2.2L ENGINE DRIVEABILITY AND EMISSION DTC P0108 MAP Sensor Circuit High Input (Cont'd) Step No Yes Value(s) Action 8 1. Ignition OFF. circuit and the 5 volt signal circuit, both at the wiring 3. Ignition ON, Engine OFF. Does the Tech 2 read the following value? 5 volts 104 kPa Go to Step 9 Go to Step 12 9 Check the MAP sensor ground circuit, between the f An open circuit f A short to ground f A short to voltage Was the problem found? — Verify repair Go to Step 10 10 1. Ignition OFF. voltage, between the ground circuit and the 5 volt 3. Ignition ON, Engine OFF. Does the DVM read the following value? 5 Volts Go to Step 11 Go to Step 12 11 Replace the MAP sensor. — — — 12 Replace the PCM. IMPORTANT: The replacement PCM must be And also refer to latest Service Bulletin. Verify repair. — — — |