TEST
ACTION
APPLICABILITY
3
Disconnect the Body Control Module C3 connector.
Disconnect the appropriate Sliding Door Control Module C2 connector.
Measure the resistance of the appropriate Sliding Door Wake Up Signal circuit
between the BCM C3 connector and the Sliding Door Control Module C2 connector.
Is the resistance below 5.0 ohms?
All
Yes
→ Go To 4
No
→ Repair the appropriate Sliding Door Wake Up Signal wire for an
open.
Perform BODY VERIFICATION TEST - VER 1.
4
Disconnect the Body Control Module C2 connector.
Disconnect the Power Liftgate Module C2 connector.
Measure the resistance between the Liftgate Module Wake Up Signal circuit and
ground.
Is the resistance below 100.0 ohms?
All
Yes
→ Repair the Liftgate Module Wake Up Signal wire for a short to
ground.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Go To 5
5
NOTE: If this vehicle is equipped with 2 power sliding doors, this test must
be repeated for each door.
Disconnect the Body Control Module C3 connector.
Disconnect the appropriate Sliding Door Control Module C2 connector.
Measure the resistance between the appropriate Sliding Door Wake Up Signal circuit
and ground.
Is the resistance below 100.0 ohms?
All
Yes
→ Repair the appropriate Sliding Door Wake Up Signal wire for a
short to ground.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Go To 6
6
If there are no possible causes remaining, view repair.
All
Repair
Replace the Sliding Door Module.
Perform BODY VERIFICATION TEST - VER 1.
911
POWER DOORS - SLIDING
IOD WAKE UP OPEN - PSD —
Continued