TEST
ACTION
APPLICABILITY
3
Turn the ignition off.
Gain access to the bottom of the Fuse and Relay Center.
Disconnect connector C9 from the Fuse and Relay Center.
Measure the resistance of the Fused Ignition Switch Output circuit between the FCM
connector cavity 37 and the Fuse and Relay Center connector C9 cavity 2.
Is the resistance below 5.0 ohms?
All
Yes
→ Repair the Fused Ignition Switch Output circuit for an open
between the Fuse and Relay Center and the ignition switch.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Replace the Fuse and Relay Center.
Perform BODY VERIFICATION TEST - VER 1.
611
IGNITION, POWER, ACCESSORY
IGNITION RUN/START INPUT WIRING —
Continued