Chrysler Voyager. Manual - part 232

 

  Index      Chrysler     Chrysler Voyager - service and repair manual

 

Search            copyright infringement  

 

 

 

 

 

 

 

 

 

Content   ..  230  231  232  233   ..

 

 

Chrysler Voyager. Manual - part 232

 

 

TEST

ACTION

APPLICABILITY

3

Turn the ignition off.
Disconnect the PCM harness connector. Note: If equipped with NGC follow the
caution below.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Measure the resistance of the PCI Bus circuit between the DLC and the PCM
connector.
Is the resistance below 5.0 ohms?

All

Yes

→ Replace and program the Powertrain Control Module in accor-

dance with the Service Information.
Perform BODY VERIFICATION TEST - VER 1.

No

→ Repair the PCI Bus circuit for an open.

Perform BODY VERIFICATION TEST - VER 1.

355

COMMUNICATION

PCM MESSAGES NOT RECEIVED —

Continued

Symptom:

RADIO MEM MSG NOT RECEIVED

When Monitored and Set Condition:

RADIO MEM MSG NOT RECEIVED

When Monitored:

With the ignition in run, and the IOD fuse installed.

Set Condition:

The BCM does not receive any radio memory messages.

POSSIBLE CAUSES

ATTEMPT TO COMMUNICATE WITH THE RADIO

CHECK THE MEMORY SYSTEM

BODY CONTROL MODULE

TEST

ACTION

APPLICABILITY

1

Turn the ignition on.
With the DRB, attempt to communicate with the Radio.
Was the DRB able to I/D or communicate with the Radio?

All

Yes

→ Go To 2

No

→ Refer to the Communication category for the related symptom(s).

Perform BODY VERIFICATION TEST - VER 1.

2

Turn the ignition on.
Operate the memory seat system.
Did the memory seat system operate properly?

All

Yes

→ Go To 3

No

→ Refer to the Memory Seat category and perform the appropriate

symptom.
Perform BODY VERIFICATION TEST - VER 1.

3

With the DRB, erase DTC’s.
Cycle the ignition switch from off to on and wait approximately 1 minute.
With the DRB, read DTC’s.
Did this DTC reset?

All

Yes

→ Replace the Body Control Module in accordance with the service

information.
Perform BODY VERIFICATION TEST - VER 1.

No

→ Test Complete.

356

COMMUNICATION

Symptom:

RIGHT PSD MESSAGES NOT RECEIVED

When Monitored and Set Condition:

RIGHT PSD MESSAGES NOT RECEIVED

When Monitored:

When the Body Control Module is awake.

Set Condition:

The BCM does not sense a response from the Right Power Sliding Door

Module.

POSSIBLE CAUSES

CHECK FOR DTCS

VERIFY DTC

ATTEMPT TO COMMUNICATE WITH THE RIGHT SLIDING DOOR CONTROL MODULE

BODY CONTROL MODULE

TEST

ACTION

APPLICABILITY

1

Turn the ignition on.
With the DRBIII

t, read BCM DTC’s.

Are any IOD Wakeup power sliding door DTC’s set?

All

Yes

→ Refer to symptom list for problems related to the IOD wakeup

circuit.
Perform BODY VERIFICATION TEST - VER 1.

No

→ Go To 2

2

Turn the ignition on.
With the DRBIII

t, erase DTC’s.

Operate the right power sliding door with either the key fob or the overhead console.
With the DRBIII

t, read BCM DTC’s.

Did this DTC reset?

All

Yes

→ Go To 3

No

→ The condition that caused this DTC is currently not present. Use

the wiring diagrams/schematic as a guide, and inspect the related
wiring harness for a possible intermittent.
Perform BODY VERIFICATION TEST - VER 1.

3

Turn the ignition on.
With the DRB, attempt to communicate with the Right Sliding Door Control Module.
Was the DRB able to I/D or communicate with the Right Sliding Door Control
Module?

All

Yes

→ Go To 4

No

→ Refer to the Communication category for the related symptom(s).

Perform BODY VERIFICATION TEST - VER 1.

357

COMMUNICATION

TEST

ACTION

APPLICABILITY

4

With the DRB, erase DTC’s.
Cycle the ignition switch from off to on and wait approximately 1 minute.
Operate the right power sliding door with either the key fob or the overhead console.
With the DRB, read DTC’s.
Did this DTC reset?

All

Yes

→ Replace the Body Control Module in accordance with the service

information.
Perform BODY VERIFICATION TEST - VER 1.

No

→ Test Complete.

358

COMMUNICATION

RIGHT PSD MESSAGES NOT RECEIVED —

Continued

 

 

 

 

 

 

 

Content   ..  230  231  232  233   ..