|
|
|
REAR KEYBOARD FAULT (STORED) When Monitored: With the ignition on and the IOD fuse installed. Set Condition: This DTC will set if there is an internal fault in the ATC head. REAR MODE DOOR NOT RESPONDING (STORED) When Monitored: With the ignition on and the IOD fuse installed. Set Condition: This DTC is set if the ATC does not receive feedback pulses within 5 seconds of the drive voltage being applied. REAR MODE DOOR TRAVEL TOO LARGE (STORED) When Monitored: With the ignition on and the IOD fuse installed. Set Condition: This DTC is set when the ATC monitors the travel range during system initialization and the measured range is greater than expected. REAR MODE DOOR TRAVEL TOO SMALL (STORED) When Monitored: With the ignition on and the IOD fuse installed. Set Condition: This DTC is set when the ATC monitors the travel range during system initialization and the measured range is less than expected. REAR MODE POT OPEN (STORED) When Monitored: With the ignition on and the IOD fuse installed. Set Condition: This DTC is set if the ATC reads the rear mode select switch value and it is above 250 A/D counts. REAR MODE POT SHORTED (STORED) When Monitored: With the ignition on and the IOD fuse installed. Set Condition: This DTC is set if the ATC reads the rear mode select switch value and it is below 5 A/D counts. RECIRC DOOR NOT RESPONDING (STORED) When Monitored: Ignition in RUN and IOD fuse installed. Set Condition: This DTC is set when the ATC does not receive feedback pulses within 5 seconds of the drive voltage being applied. RECIRC DOOR TRAVEL TOO LARGE (STORED) When Monitored: Ignition in RUN and IOD fuse installed. Set Condition: This DTC is set when the ATC monitors the travel range during system initialization and the measured range is greater than expected. 203 AUTOMATIC TEMPERATURE CONTROL AC PRESSURE TOO HIGH (STORED) — Continued |