TEST
ACTION
APPLICABILITY
7
Turn the ignition off.
Disconnect the Brake Lamp Switch harness connector.
Measure the resistance between the Ground circuit terminal and the Brake Switch
Sense terminal in the Brake Lamp Switch.
Apply and release the brake pedal while monitoring the ohmmeter.
Does the resistance change from below 5.0 ohms to open circuit?
All
Yes
→ Go To 8
No
→ Replace the Brake Lamp Switch.
Perform POWERTRAIN VERIFICATION TEST VER - 4 - NGC.
8
NOTE: Before continuing, check the PCM harness connector terminals for
corrosion, damage, or terminal push out. Repair as necessary.
If there are no possible causes remaining, view repair.
All
Repair
Replace and program the Powertrain Control Module in accor-
dance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 4 - NGC.
447
DRIVEABILITY - NGC
P0703-BRAKE SWITCH #2 CIRCUIT —
Continued