TEST
ACTION
APPLICABILITY
3
Turn the ignition off.
Remove the ASD Relay from the IPM.
Turn the ignition on.
Using a 12-volt test light connected to 12-volts, probe the ASD Relay Control circuit
in the IPM.
With the DRBIII
t, actuate the ASD Relay.
Does the test light flash on and off?
All
Yes
→ Replace the ASD Relay.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
No
→ Go To 4
4
Turn the ignition off.
Disconnect the Intelligent Power Module C3 harness connector.
Turn the ignition on.
Using a 12-volt test light connected to 12-volts, probe the ASD Relay Control circuit
in the IPM harness connector.
With the DRBIII
t, actuate the ASD Relay.
Does the test light flash on and off?
All
Yes
→ Replace the IPM Fused & Relay Center.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
No
→ Go To 5
5
Turn the ignition off.
Disconnect the Intelligent Power Module C3 harness connector.
Disconnect the PCM harness connector.
Measure the resistance of the (K51) ASD Relay Control circuit between the Intelli-
gent Power Module C3 harness connector and the PCM harness connector.
Is the resistance below 5.0 ohms.
All
Yes
→ Go To 6
No
→ Repair the open in the (K51) ASD Relay Control circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
6
Turn the ignition off.
Disconnect the Intelligent Power Module C3 harness connector.
Disconnect the PCM harness connector.
Measure the resistance of the (K51) ASD Relay Control circuit in the Intelligent
Power Module C3 harness connector to ground.
Is the resistance below 5.0 ohms.
All
Yes
→ Repair the short to ground in the (K51) ASD Relay Control circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
No
→ Go To 7
7
NOTE: Before continuing, check the PCM harness connector terminals for
corrosion, damage, or terminal push out. Repair as necessary.
Using the schematics as a guide, inspect the wire harness and connectors. Pay
particular attention to all Power and Ground circuits.
If there are no possible causes remaining, view repair.
All
Repair
Replace and program the Powertrain Control Module Module in
accordance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
163
DRIVEABILITY - SBEC
P1388-AUTO SHUTDOWN RELAY CONTROL CIRCUIT —
Continued