Daewoo Matiz (2003 year). Service manual - part 293

9T – 28  IMMOBILIZER ANTI-THEFT SYSTEM

DAEWOO M–150 BL2

D29T002

Installation Procedure

1. Install the detection coil by pressing it onto the lock

cylinder until it snaps in place.

2. Connect the two-pin connector to the immobilizer.

D105A505

3. Install the steering column covers with the screws.

Refer to Section 6E, Steering Wheel and Column.

D105A504

IMMOBILIZER CONTROL UNIT

(Left–Hand Drive Shown, Right–Hand
Drive Similar)

Removal Procedure

1. Disconnect the negative battery cable.

2. Remove the steering column covers. Refer to Section

6E, Steering Wheel and Column.

D29T003

3. Slide the immobilizer control unit toward steering

wheel until it slides off its mounting bracket.

4. Disconnect the electrical connectors from the immo-

bilizer control unit (1).

IMMOBILIZER ANTI-THEFT SYSTEM  9T – 29

DAEWOO M–150 BL2

D29T004

Installation Procedure

 After replacing the immobilizer control unit, the keys
must be re-authorized using the key coding procedure.
Refer to “Key Coding Procedure” in this section. Also,
the electronic control module (ECM) identification (ID)
code must be reset. Refer to “Identification (ID) Code
Reprogramming” in this section.

1. Connect the electrical connectors to the immobilizer

control unit.

2. Slide the immobilizer control unit onto its mounting

bracket.

D105A505

3. Install the steering column covers. Refer to Section

6E, Steering Wheel and Column.

4. Connect the negative battery cable.

9T – 30  IMMOBILIZER ANTI-THEFT SYSTEM

DAEWOO M–150 BL2

SPECIFICATIONS

FASTENER TIGHTENING SPECIFICATIONS

ÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑ

ÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑÑ

Application

ÑÑÑÑÑÑÑ

ÑÑÑÑÑÑÑ

N

S

m

ÑÑÑÑÑÑ

ÑÑÑÑÑÑ

Lb-Ft

ÑÑÑÑÑÑÑ

ÑÑÑÑÑÑÑ

Lb-In

Immobilizer Control Unit Mounting Bolts

4

–

35

IMMOBILIZER ANTI-THEFT SYSTEM  9T – 31

DAEWOO M–150 BL2

SCHEMATIC AND ROUTING DIAGRAMS

D19T001B

IM

M

O

BI

L

IZ

E

R ANT

I-

T

H

EF

T

 SYST

EM