Daewoo Nubira. Service manual - part 16

Description

Page

Paint Codes

3 of 3

November, 1998

Paint Manufacturer Telephone Numbers:

Akzo

Customer Assistance  . . . . . . . . . . . . . . .(800) 618-1010

Dupont

Customer Assistance  . . . . . . . . . . . . . . .(800) 338-7668

PPG

Color Library/Codes/Formulas  . . . . . . .(440) 572-6100

Technical Assistance  . . . . . . . . . . . . . . .(440) 572-6111

Sherwin Williams

Customer Assistance  . . . . . . . . . . . . . . .(800) 798-5872

Martin Senour

Customer Assistance  . . . . . . . . . . . . . . .(800) 526-6704

TECHNICAL SERVICE BULLETIN

TECHNICAL SERVICE BULLETIN

Description:

Reference:

Prod. Dates:

Bulletin No.:

Model(s):

Date:

VIN Range:

Group:

TSB-002-98

1998-99 Nubira 5-Door

November 25, 1998

See Attached

Rear Hatch Lock Rod

Body

N/A

N/A

General Manager
Service Manager

Technician(s)
Service Advisor

Body Shop Manager
Parts Manager

Circulate To:

√

√
√

√
√

√

For some Nubira 5-Door models, it is possible that
the alarm may be triggered when opening the rear
hatch with the key.  If the key is rotated slowly, it is
possible that the rear latch could be released before
the lock switch disables the alarm system.  To correct
this condition, Daewoo has developed an updated
rear hatch lock rod which is 5 mm shorter than the
original rod.

A supply of updated lock rods has been shipped to
your location and are available for customer
complaints/concerns.

All applicable Store stock units should be immediately updated with the new lock rod.
Affected customer vehicles, demonstrators, DCA vehicles, etc. should be updated as they
come in for periodic service and/or repairs regardless if a complaint has been made.

A list of applicable Nubira 5-Door Vehicle Identification Numbers (VIN’s) has been attached
for your reference.

REAR HATCH LOCK ROD REMOVAL / INSTALLATION INSTRUCTIONS

Lock Rod Removal:
1.

Raise the rear hatch to its fully opened position.

2.

Remove the rear hatch inner trim panel by
removing and retaining the four (4) screws and
three (3) trim panel clips.

Rear Hatch
Inner Trim Panel

“New”
Lock Rod

“Old”
Lock Rod

Description

Page

Rear Hatch Lock Rod

2 of 2

November, 1998

3.

Release the two (2) lock rod plastic lock tabs
and remove the lock rod.

Lock Rod Installation:
1.

Install the new lock rod and reattach the two (2)
plastic lock tabs.

2.

Reinstall the rear hatch inner trim panel, the
four (4) retaining screws and the three (3) trim
panel clips.

3.

Verify the operation of the latch rod by first
setting the alarm system, then opening the rear
hatch by slowly rotating the key in the cylinder.

Parts Information:

Part Name

Part Number

Qty. Req’d

Rod-Key Cyl, T/Gate

96237711

1

Warranty Information:

Operation Code

Operation Description

Labor Time

F896112

Rod, T/Gate Lock, Replace

0.2 hr

Causal Part Number: 96301830

Nature Code: N65

Cause Code: R31

“Old”
Lock Rod

“New”
Lock Rod

SECTION : 9O

BUMPERS AND FASCIAS

CAUTION : Disconnect the negative battery cable before removing or installing any electrical unit or when a tool
or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable will help
prevent personal injury and damage to the vehicle. The ignition must also be in LOCK unless otherwise noted.

TABLE OF CONTENTS

SPECIFICATIONS 

9O–1

. . . . . . . . . . . . . . . . . . . . . . . . . . 

FASTENER TIGHTENING SPECIFICATIONS

9O–1

. 

MAINTENANCE AND REPAIR

9O–2

. . . . . . . . . . . . . . . 

ON–VEHICLE SERVICE

9O–2

. . . . . . . . . . . . . . . . . . . . . 

FRONT BUMPER FASCIA

9O–2

. . . . . . . . . . . . . . . . . . 

FRONT BUMPER ENERGY ABSORBER

9O–6

. . . . . 

FRONT BUMPER IMPACT BAR

9O–6

. . . . . . . . . . . . . 

REAR BUMPER FASCIA

9O–8

. . . . . . . . . . . . . . . . . . . 

REAR BUMPER ENERGY ABSORBER

9O–11

. . . . . 

REAR BUMPER IMPACT BAR

9O–12

. . . . . . . . . . . . . 

GENERAL DESCRIPTION AND SYSTEM

OPERATION

9O–14

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 

BUMPERS

9O–14

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 

SPECIFICATIONS

FASTENER TIGHTENING SPECIFICATIONS

Application

N

S

m

Lb–Ft

Lb–In

Fender–to–Fascia Bolts

1.5

–

13

Front Impact Bar Bolts

35

26

–

Front Impact Bar Nuts

22

16

–

Front Wheel Well Fascia
Bolts

1.5

–

13

Front Wheel Well Splash
Shield Bolts

1.5

–

13

Luggage Compartment
Fascia Bolts

8

–

71

Rear Impact Bar Bolts

35

26

–

Rear Impact Bar Bracket
Nuts

30

22

–

Rear Wheel Mud Guard
Bolts

1.5

–

13

Rear Wheel Well Fascia
Bolts

1.5

–

13

Rear Wheel Well Splash
Shield Bolts

1.5

–

13