|
|
Content .. 1475 1476 1477 1478 ..
1. Install the drive pinion, if necessary. Refer to Drive Pinion and Ring Gear Replacement (8.6, 9.5/9.5LD, and 11.5 Inch Axles) or Drive Pinion and Ring Gear Replacement 2. Measure the rotating torque of the drive pinion using an inch-pound torque wrench. Record the measurement. Specification: The rotating torque for the drive pinion bearings should be 1.7-3.4 N.m (15- 3. If the rotating torque for the drive pinion bearings is not within specifications, adjust as necessary. Refer to Drive Pinion and Ring Gear Replacement (8.6, 9.5/9.5LD, and 11.5 4. Install the differential assembly with the differential side bearings and bearing cups into the axle housing. 5. Insert one BENT 1.016 mm (0.040 in) thick service shim into the right side axle housing. Side the differential assembly towards the bent service shim in order to hold the shim in 6. While holding the differential assembly against the bent service shim, install one 4.318 mm (0.170 in) thick service spacer into the left side axle housing. 7. Move the differential assembly to the right until the ring gear contacts the drive pinion. Once the ring gear contacts the drive pinion, continue to move the ring gear towards the 8. While holding the ring gear against the drive pinion, insert progressively larger service In order to maintain the original backlash, adjust the Measure the service shims and the service spacers one at a Do not use or reuse the original cast iron production shims. IMPORTANT: Before installation of the case assembly, ensure that the side bearing surfaces in the axle housing are clean and free of
2008 Chevrolet Silverado 1500 2008 Driveline/Axle Rear Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
|