|
|
|
back into the retractor. As the webbing retracts, you will 6. Try to pull the webbing out of the retractor. If it is locked, you should not be able to pull out any webbing. 7. Finally, pull up on any excess webbing to tighten the lap portion around the child restraint while you push the 8. If the child restraint has a top tether strap and the seating position has a top tether anchorage, connect the 9. Test that the child restraint is installed tightly by pulling back and forth on the child seat at the belt path. It Any seat belt system will loosen with time, so check the Installing A Child Restraint With A Switchable Crew Cab 1. Place the child seat in the center of the seating position. Move the vehicle seat as far rearward as possible to keep 2. Pull enough of the seat belt webbing from the retractor to pass it through the belt path of the child restraint. Do 3. Slide the latch plate into the buckle until you hear a “click.” 4. Pull on the webbing to make the lap portion tight against the child seat. 5. To lock the seat belt, pull down on the shoulder part of the belt until you have pulled all the seat belt webbing 2 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 85 |