|
|
|
Your vehicle has a simple ignition actuated test, which 1. Cycle the ignition switch to the ON position, but do not crank or start the engine. NOTE: If you crank or start the engine, you will have to start this test over. 2. As soon as you cycle the ignition switch to the ON position, you will see the Malfunction Indicator Light 3. Approximately 15 seconds later, one of two things will happen: • The MIL will flash for about 10 seconds and then return to being fully illuminated until you turn OFF the ignition or start the engine. This means that your proceed to the I/M station. • The MIL will not flash at all and will remain fully illuminated until you place the ignition in the off If your OBD II system is not ready, you should see your Regardless of whether your vehicle’s OBD II system is 636 MAINTAINING YOUR VEHICLE |