|
|
------------------------------------------------------------------------------------------------------------------------------------------------------------- The essentials Starting boosting battery and let it run at idling 8. Start the engine of the vehicle with the flat battery and wait for 2 or 3 minutes until Removing the jump leads off the dipped beam headlights if they are 10.Turn on the heater blower and heated rear window in the vehicle with the flat battery. 11.When the engine is running, disconnect the leads in reverse order to the details Make sure the battery clamps have sufficient If the engine fails to start, switch off the start- WARNING ● Please note the safety warnings referring to working in the engine compartment ››› ● The battery providing assistance must have the same voltage as the flat battery (12V) and ● Never use jump leads when one of the bat- teries is frozen. Danger of explosion! Even af- ● Keep sparks, flames and lighted cigarettes away from batteries, danger of explosion. ● Observe the instructions provided by the manufacturer of the jump leads. ● Do not connect the negative cable from the other vehicle directly to the negative terminal ● Do not attach the negative cable from the other vehicle to parts of the fuel system or to ● The non-insulated parts of the battery clamps must not be allowed to touch. The ● Position the leads in such a way that they cannot come into contact with any moving ● Do not lean on the batteries. This could re- sult in chemical burns. Note The vehicles must not touch each other, oth- Changing the windscreen wiper Changing the wiper blades Fig. 69 Windscreen wiper blades. Set the windscreen wiper arms to the service » 53 |