Polaris Sportsman 570 (2018 year). Instruction - part 18

 

  Index      Snowmobiles / ATV     Polaris Sportsman 570 - instruction 2018 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  16  17  18  19   ..

 

 

Polaris Sportsman 570 (2018 year). Instruction - part 18

 

 

STARTING THE ENGINE

1. Position the vehicle on a level surface outdoors or in a well- ventilated area.

2. Place the transmission in PARK.

3. Lock the parking brake.

TIP

The starter interlock will prevent the engine from starting if the transmission is

in gear and the brake is not engaged.

4. Sit on the vehicle and move the engine stop switch to RUN.

TIP

Do not press the throttle while starting the engine.

5. Turn the ignition key past the ON position to engage the starter. Activate the

starter for a maximum of five seconds, releasing the key when the engine
starts.

6. If the engine does not start, return the key to the OFF position and wait five

seconds before attempting to start again. Activate the starter for another five
seconds if necessary. Repeat this procedure until the engine starts.

NOTICE

Operating the vehicle immediately after starting could cause engine damage.

Allow the engine to warm up for several minutes before operating the vehicle.

STOPPING THE ENGINE

1. Release the throttle pedal completely and brake to a complete stop.

2. Place the transmission in PARK.

3. Turn the engine off.

4. Slowly release the brake pedal and make sure the transmission is in PARK

before exiting the vehicle.

WARNING

A rolling vehicle can cause serious injury. Always place the transmission in

PARK when stopping the engine.

74

OPERATION

PARKING THE VEHICLE

1. Stop the vehicle on a level surface. When parking inside a garage or other

structure, be sure that the structure is well ventilated and that the vehicle is
not close to any source of flame or sparks, including any appliance with pilot
lights.

2. Place the transmission in PARK.

3. Turn the engine off.

4. Engage the parking brake (if equipped).

5. Slowly release the brake pedal and make sure the transmission is in PARK

before exiting the vehicle.

6. Remove the ignition key to prevent unauthorized use.

COLD WEATHER OPERATION

If the vehicle is used year-round, check the oil level frequently. A rising oil level
could indicate the accumulation of contaminates such as water or excess fuel in
the bottom of the crankcase. Water in the bottom of the crankcase can lead to
engine damage and must be drained. Water accumulation increases as outside
temperature decreases.

See your dealer for engine heater kits, which provide quicker warm-ups and
easier starting in colder weather.

75

OPERATION

DRIVING PROCEDURES

1. Wear protective riding gear. See the Safe Riding Gear section.

2. Perform the pre-ride inspection.

3. Place the transmission in PARK.

4. Lock the parking brake.

5. Mount the vehicle from the left side.

6. Sit upright with both feet on the footrests and both hands on the handlebars.

7. Start the engine and allow it to warm up.

8. Shift the transmission into gear.

9. Check your surroundings and determine your path of travel.

10. Release the parking brake.

11. Slowly depress the throttle with your right thumb and begin driving.

12. Drive slowly. Practice maneuvering and using the throttle and brakes on level

surfaces.

DRIVING WITH A PASSENGER

1. Never carry more than one passenger on a 2-up vehicle.

2. Do not carry a passenger on a 2-up vehicle until you have at least two hours

of driving experience with the vehicle.

3. Never allow anyone under 12 years of age to ride as a passenger on a 2-up

vehicle. Make sure any passenger is tall enough to comfortably and safely
reach the grab handles and footrests. Allow a passenger to ride only in the
approved passenger seat.

4. Make sure the passenger is wearing appropriate riding gear, including an

approved helmet with a rigid chin guard. See the Rider Comfort section for
details.

5. Perform the pre-ride inspection. See the Pre-Ride Checklist section for

details.

6. Lock the parking brake.

76

OPERATION

7. Mount the vehicle from the left side. After the operator is seated, the

passenger should mount the vehicle from the left side. Always make sure the
brake is engaged to ensure the vehicle remains motionless whenever a
passenger mounts or dismounts.

8. Slow down. Control may be more difficult with a passenger on board. Allow

more time and distance for braking.

9. Ride to the ability of your passenger, instead of to your own ability. Avoid

unexpected or aggressive maneuvers that could cause a passenger to fall
from the vehicle.

10. Do not cross a hillside with a passenger on board.

11. A passenger should always be seated in the passenger seat with both feet

on the footrests and both hands on the passenger grab handles at all times.
The passenger should never hold on to the operator. Never secure a
passenger to the vehicle or to the operator with a belt, rope or similar device.

12. Make sure the passenger understands the importance of “active riding.”

When hill-climbing or performing maneuvers, a passenger should shift body
weight in the same manner in which the driver shifts body weight. For
example, the passenger should lean to the inside of a turn along with the
operator and should always lean uphill when climbing and descending hills.

77

OPERATION

 

 

 

 

 

 

 

Content   ..  16  17  18  19   ..