|
|
INSPECTION AND ADJUSTMENT EC-371 < BASIC INSPECTION > [HR16DE (WITHOUT EURO-OBD)] C D E F G H I J K L M A EC N P O Engine component parts and their installation condition are questionable. Check and eliminate the cause of If any of the following conditions occur after the engine has started, eliminate the cause of the incident and >> INSPECTION END MIXTURE RATIO SELF-LEARNING VALUE CLEAR MIXTURE RATIO SELF-LEARNING VALUE CLEAR : Description INFOID:0000000001096738 This describes how to erase the mixture ratio self-learning value. For the actual procedure, follow the instruc- MIXTURE RATIO SELF-LEARNING VALUE CLEAR : Special Repair Requirement INFOID:0000000001096739 1. START With CONSULT-III 1. Start engine and warm it up to normal operating temperature. 2. Select “SELF-LEARNING CONT” in “WORK SUPPORT” mode with CONSULT-III. 3. Clear mixture ratio self-learning value by touching “CLEAR”. Without CONSULT-III 1. Start engine and warm it up to normal operating temperature. 2. Turn ignition switch OFF. 3. Disconnect mass air flow sensor harness connector, and restart and run engine for at least 5 seconds at 4. Stop engine and reconnect mass air flow sensor harness connector. 5. Make sure that DTC P0102 is displayed. 6. Erase the DTC memory. Refer to EC-426, "Diagnosis Description" 7. Make sure that DTC P0000 is displayed. >> END |