Nissan Qashqai (2007-2010). Manual - part 1141

 

  Index      Nissan     Nissan Qashqai - service and repair manual 2007 - 2010 year

 

Search            copyright infringement  

 

 

 

 

 

 

 

 

 

Content   ..  1139  1140  1141  1142   ..

 

 

Nissan Qashqai (2007-2010). Manual - part 1141

 

 

BCM (BODY CONTROL MODULE)

DLK-643

< ECU DIAGNOSIS >

[WITHOUT I-KEY & SUPER LOCK]

C

D

E

F

G

H

I

J

L

M

A

B

DLK

N

O

P

REAR WIPER CONTROL

BCM detects a rear wiper stopping position according to a rear wiper auto stop signal.
When a rear wiper auto stop signal is in the condition listed below, BCM stops power supply to rear wiper after
rear wiper is activated for five seconds.

NOTE:
The above operation is repeated when operating the rear wiper switch one minute after the stop of the rear
wiper caused by Fail-safe.

TURN SIGNAL LAMP CONTROL

BCM detects the turn signal lamp circuit status from the terminal voltage.
BCM increases the turn signal lamp blinking speed if the bulb or harness open is detected with the turn signal
lamp operating.
NOTE:
The blinking speed is normal while activating the hazard warning lamp.

LIGHT & RAIN SENSOR MALFUNCTION DETECTION FUNCTION

BCM controls the following items when LIGHT & RAIN sensor has a malfunction.

Auto Light Control

Headlamp is turned ON.

Front Wiper Control

The condition just before the activation of Fail-safe is maintained until the front wiper switch is turned OFF.

DTC Inspection Priority Chart

INFOID:0000000001116445

Display contents of CONSULT

Fail-safe

Cancellation

B2190: NATS ANTENNA AMP

• Inhibits engine cranking
• Inhibits steering lock unlocking (Intelligent Key unit)
• Fuel  cut  (ECM)

Erase DTC

B2191: DIFFERENCE OF KEY

• Inhibits engine cranking
• Inhibits steering lock unlocking (Intelligent Key unit)
• Fuel  cut  (ECM)

Erase DTC

B2192: ID DISCORD BCM-ECM

Fuel cut (ECM)

Erase DTC

B2193: CHAIN OF BCM-ECM

Fuel cut (ECM)

Erase DTC

B2194: DISCORD BCM-I-KEY

• Inhibits engine cranking
• Inhibits steering lock unlocking (Intelligent Key unit)
• Fuel  cut  (ECM)

Erase DTC

B2195: ANTI SCANNING

• Inhibits engine cranking
• Inhibits steering lock unlocking (Intelligent Key unit)
• Fuel  cut  (ECM)

Erase DTC

B2196: DONGLE NG

• Inhibits engine cranking
• Inhibits steering lock unlocking (Intelligent Key unit)
• Fuel  cut  (ECM)

Erase DTC

Ignition switch 

Rear wiper switch

Auto stop signal

ON

OFF

Rear wiper stop position signal cannot be 
input 5 seconds.

ON

The signal does not change for 5 seconds.

DLK-644

< ECU DIAGNOSIS >

[WITHOUT I-KEY & SUPER LOCK]

BCM (BODY CONTROL MODULE)

DTC Index

INFOID:0000000001116446

NOTE:

Details of time display

• CRNT: Displays when there is a malfunction now or after returning to the normal condition until turning igni-

tion switch OFF 

 ON again.

• PAST: Displays when there is a malfunction that is detected in the past and stored.
• 1 - 39: Displayed if any previous malfunction is present when current condition is normal. It increases like 1

 2 

 3...38 

 39 after returning to the normal condition whenever ignition switch OFF 

 ON. The counter

remains at 39 even if the number of cycles exceeds it. It is counted from 1 again when turning ignition switch
OFF 

 ON after returning to the normal condition if the malfunction is detected again.

Priority

DTC

1

• U1000: CAN COMM CIRCUIT
• U1010: CONTROL UNIT (CAN)

2

• B2190: NATS ANTENNA AMP
• B2191: DIFFERNCE OF KEY
• B2192: ID DISCORD BCM-ECM
• B2193: CHAIN OF BCM-ECM
• B2194: DISCORD BCM-I-KEY
• B2195: ANTI SCANNING
• B2196: DONGLE NG

CONSULT display

TIME

Fail-safe

Refer to

No DTC is detected.
further testing
may be required.

U1000: CAN COMM CIRCUIT

0

1 - 39

BCS-32

U1010: CONTROL UNIT (CAN)

0

1 - 39

BCS-33

B2190: NATS ANTENNA AMP

CRNT

PAST

×

• With Intelligent Key system 

SEC-33

• Without Intelligent Key system 

SEC-

174

B2191: DIFFERENCE OF KEY

CRNT

PAST

×

• With Intelligent Key system 

SEC-35

• Without Intelligent Key system 

SEC-

176

 

B2192: ID DISCORD BCM-ECM

CRNT

PAST

×

• With Intelligent Key system 

SEC-36

• Without Intelligent Key system 

SEC-

177

B2193: CHAIN OF BCM-ECM

CRNT

PAST

×

• With Intelligent Key system 

SEC-38

• Without Intelligent Key system 

SEC-

178

B2194: DISCORD BCM-I-KEY

CRNT

PAST

×

SEC-39

B2195: ANTI SCANNING

CRNT

PAST

×

• With Intelligent Key system 

SEC-179

• Without Intelligent Key system 

SEC-

179

B2196: DONGLE NG

CRNT

PAST

×

• With Intelligent Key system 

SEC-41

• Without Intelligent Key system 

SEC-

180

 

DOOR LOCK FUNCTION SYMPTOMS

DLK-645

< SYMPTOM DIAGNOSIS >

[WITHOUT I-KEY & SUPER LOCK]

C

D

E

F

G

H

I

J

L

M

A

B

DLK

N

O

P

SYMPTOM DIAGNOSIS

DOOR LOCK FUNCTION SYMPTOMS

DOOR LOCK AND UNLOCK SWITCH

DOOR LOCK AND UNLOCK SWITCH : Symptom Table

INFOID:0000000001093366

DOOR LOCK AND UNLOCK SWITCH OPERATION MALFUNCTION

NOTE:
• Before performing the diagnosis in the following table, check “Work Flow”. Refer to 

DLK-553, "Work Flow"

.

• Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and

check each symptom.

• If the following symptoms are detected, check systems shown in the “Diagnosis/service procedure” column

in this order.

Conditions of Vehicle (Operating Conditions)

• Except driver side, doors are closed.
• Doors are not locked by keyfob.

Symptom Table

KEYFOB

KEYFOB : Symptom Table

INFOID:0000000001093368

KEYFOB OPERATION MALFUNCTION

NOTE:
• Before performing the diagnosis in the following table, check “WORK FLOW”. Refer to 

DLK-553, "Work

Flow"

.

• Check that vehicle is under the condition shown in “Conditions of Vehicle” before starting diagnosis, and

check each symptom.

• If the following symptoms are detected, check systems shown in the “Diagnosis/service procedure” column

in this order.

Conditions of Vehicle (Operating Conditions)

• Mechanical key is removed from ignition key cylinder.
• Door lock and unlock operation is normal.

Symptom Table

Symptom

Diagnosis/service procedure

Reference 

page

Door lock and unlock function does not oper-
ate with door lock and unlock switch.

1.

Check BCM power supply and ground circuit.

DLK-584

2.

Check door lock and unlock switch.

DLK-585

3.

Check door switch.

Passenger side

DLK-590

Rear LH

DLK-592

Rear RH

DLK-593

Back door

DLK-595

4.

Check intermittent incident.

GI-39

Specific door lock actuator does not operate.

1.

Check door lock actuator.

Driver side

DLK-599

Passenger side

DLK-600

Rear LH

DLK-602

Rear RH

DLK-603

2.

Check intermittent incident.

GI-39

DLK-646

< SYMPTOM DIAGNOSIS >

[WITHOUT I-KEY & SUPER LOCK]

DOOR LOCK FUNCTION SYMPTOMS

AUTO DOOR LOCK

AUTO DOOR LOCK : Symptom Table

INFOID:0000000001093370

AUTO DOOR LOCK OPERATION MALFUNCTION

NOTE:
• Before performing the diagnosis in the following table, check “Work Flow”. Refer to 

DLK-553, "Work Flow"

.

• To understand the operation when it does work, refer to 

DLK-563, "AUTO DOOR LOCK : System Descrip-

tion"

.

• Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and

check each symptom.

• If the following symptoms are detected, check systems shown in the “Diagnosis/service procedure” column

in this order.

Conditions of Vehicle (Operating Conditions)

• “AUTO LOCK SET” is ON when setting on CONSULT-III.
• Door lock and unlock function is normal.

Symptom Table

VEHICLE SPEED SENSING AUTO DOOR LOCK

VEHICLE SPEED SENSING AUTO DOOR LOCK : Symptom Table

INFOID:0000000001093372

VEHICLE SPEED SENSING AUTO DOOR LOCK OPERATION MALFUNCTION

NOTE:
• Before performing the diagnosis in the following table, check “Work Flow”. Refer to 

DLK-553, "Work Flow"

.

• To understand the operation when it does work, refer to 

DLK-565, "VEHICLE SPEED SENSING AUTO

DOOR LOCK : System Description"

.

• Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and

check each symptom.

• If the following symptoms are detected, check systems shown in the “Diagnosis/service procedure” column

in this order.

Conditions of Vehicle (Operating Conditions)

• Door lock and unlock switch operation is normal.

Symptom

Diagnosis/service procedure

Reference 

page

All of the keyfob operations do not operate.

1.

Check keyfob battery inspection.

DLK-612

2.

Check key switch

DLK-597

3.

Check intermittent incident.

GI-39

Anti-hijack operation does not operate.

1.

Check “SECURITY DOOR LOCK SET” setting in “WORK 
SUPPORT”.

DLK-578

2.

Check intermittent incident.

GI-39

Symptom

Diagnosis/service procedure

Reference 

page

Auto door lock operation does not operate.

1.

Check “AUTO LOCK SET” setting in “WORK SUPPORT”.

DLK-580

2.

Check door switch.

Driver side

DLK-589

Passenger 
side

DLK-590

Rear LH

DLK-592

Rear RH

DLK-593

Back door

DLK-595

3.

Check key switch.

DLK-597

4.

Check intermittent incident.

GI-39

 

 

 

 

 

 

 

Content   ..  1139  1140  1141  1142   ..