Jaguar X-Type Sedan and Estate (Wagon). Service manual - part 542

 

  Index      Jaguar     Jaguar X-Type Sedan and Estate (Wagon) (2.0 L, 2.5 L and 3.0 L Gasoline; 2.0 L and 2.2 L, Diesel) - manual service 2001-2009 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  540  541  542  543   ..

 

 

Jaguar X-Type Sedan and Estate (Wagon). Service manual - part 542

 

 

8. NOTE: Right-hand shown, left-hand similar.

Detach the B-pillar upper trim panel from the B-pillar trim lower trim
panel.

9. Remove both C-pillar trim panel.

For additional information, refer to: 

C-Pillar Trim Panel - W agon

 (501-05

Interior Trim and Ornamentation, Removal and Installation).

10. Detach the covers to expose the screws and remove the driver and

passenger assist handles.

11. Remove both D-pillar trim panels.

For additional information, refer to: 

D-Pillar Trim Panel

 (501-05 Interior

Trim and Ornamentation, Removal and Installation).

12. NOTE: Right-hand shown, left-hand similar.

Remove the luggage net retaining clip.

13. NOTE: The liftgate weatherstrip must be replaced once removed.

Remove and discard the liftgate opening weatherstrip.

14. Detach the headliner.

15. 

CAUTION: The headliner must not be creased or folded during

removal or installation. Failure to follow this instruction may result in
damage to the component.

Lower the headliner.

Remove the sunroof opening panel weatherstrip.

16. Disconnect the sunroof motor electrical connector.

17. Disconnect the rear washer hose connector.

18. Disconnect the electrical connector.

19. Detach the antenna harness.

20. Disconnect the electrical connectors.

21. Remove the antenna.

Installation

1. To install, reverse the removal procedure.

Tighten to 7 Nm.

2. NOTE: The liftgate weatherstrip must be replaced once removed.

Install a new liftgate opening weatherstrip.

Published: 11-May-2011

Antenna - Module

Removal and Installation

Removal

1. Remove the C-pillar trim. For additional information, refer toSection

501-05 Interior Trim and Ornamentation

.

2. Disconnect the antenna cable electrical connector.

3. Detach the module.

1. Remove the module retaining bolt.

2. Detach the module.

4. Remove the module.

Disconnect the module electrical connectors.

Installation

1. To install, reverse the removal procedure.

Tighten to 9 Nm.

 

 

 

 

 

 

 

Content   ..  540  541  542  543   ..