Honda Insight (2019 year). Manual - part 7

95

uu

Indicators

u

Continued

In

strum

e

nt Pa

nel

*1:Canadian models only: Apply and hold the brake pedal before selecting the ON mode.

Indicator

Name

On/Blinking

Explanation

Message

*1

Immobilizer 
System 
Indicator

• Blinks if the immobilizer system 

cannot recognize the key 
information.

• Blinks - You cannot start the power 

system. Set the power mode to VEHICLE 
OFF

*1

, then select the ON mode again.

• Repeatedly blinks - The system may be 

malfunctioning. Have your vehicle 
checked by a dealer.

• Do not attempt to alter this system or add 

other devices to it. Electrical problems can 
occur.

Security System 
Alarm Indicator

• Blinks when the security system 

alarm has been set.

2 Security System Alarm P. 184

—

Indicator

Indicator

96

uu

Indicators

u

In

strum

e

nt Pa

nel

Indicator

Name

On/Blinking

Explanation

Message

System 
Message 
Indicator

• Comes on along with a beep when 

a problem is detected. A system 
message on the driver information 
interface appears at the same time.

• While the indicator is on, press the 

 

(home) button to see the message again.

2 Accessing contents in the main 

display P. 131

• Refer to the Indicators information in this 

chapter when a system message appears 
on the driver information interface. Take 
the appropriate action for the message.

• The driver information interface does not 

return to the normal screen unless the 
warning is canceled, or the left selector 
wheel is pressed.

—

ECON Mode 
Indicator

• Comes on when the ECON mode is 

on.

2 ECON Mode P. 467

SPORT Mode 
Indicator

• Comes on when you press the 

SPORT button.

• The ambient meter remains lit up in 

red as long as SPORT mode is on.

2 SPORT Mode P. 463

97

uu

Indicators

u

Continued

In

strum

e

nt Pa

nel

Indicator

Name

On/Blinking

Explanation

Message

Adaptive 
Cruise Control 
(ACC) with Low 
Speed Follow 
(LSF) Indicator 
(Amber)

●

Comes on if there is a problem with 
ACC with LSF.

●

Stays on constantly - Have your vehicle 
checked by a dealer.

●

Indicator may come on temporarily 
when the Maximum Load Limit is 
exceeded.

●

ACC with LSF has been 
automatically canceled.

●

Make sure the total load is within the 
Maximum Load Limit.

2 Maximum Load Limit P. 445

●

Stays on constantly - Have your vehicle 
checked by a dealer.

●

Comes on if the ACC with LSF is 
deactivated temporarily after the 
12-volt battery has been 
disconnected, then re-connected.

●

Drive a short distance at more than 12 
mph (20 km/h). The indicator should go 
off. If it does not, have your vehicle 
checked by a dealer.

98

uu

Indicators

u

In

strum

e

nt Pa

nel

Indicator

Name

On/Blinking

Explanation

Message

Adaptive 
Cruise Control 
(ACC) with Low 
Speed Follow 
(LSF) Indicator 
(Green)

●

Comes on when you press the 
MAIN button.

2 Adaptive Cruise Control (ACC) with 

Low Speed Follow (LSF) P. 492

—

Lane Keeping 
Assist System 
(LKAS) 
Indicator 
(Amber)

●

Comes on if there is a problem with 
the LKAS.

●

Stays on constantly - Have your vehicle 
checked by a dealer.

Lane Keeping 
Assist System 
(LKAS) 
Indicator 
(Green)

●

Comes on when you press the 
MAIN button.

2 Lane Keeping Assist System (LKAS) 

P. 509

—

99

uu

Indicators

u

Continued

In

strum

e

nt Pa

nel

Indicator

Name

On/Blinking

Explanation

Message

Safety Support 
Indicator 
(Amber)

●

Comes on if there is a problem with 
RDM or CMBS

TM

.

●

Stays on constantly - Have your vehicle 
checked by a dealer.

●

Indicator may come on temporarily 
when the Maximum Load Limit is 
exceeded.

●

Make sure the total load is within the 
Maximum Load Limit.

2 Maximum Load Limit P. 445

●

Stays on constantly - Have your vehicle 
checked by a dealer.

●

Comes on if the RDM and CMBS

TM

 

are deactivated temporarily after 
the 12-volt battery has been 
disconnected and then re-
connected.

●

Drive a short distance at more than 12 
mph (20 km/h). The indicator should go 
off. If it does not, have your vehicle 
checked by a dealer.

100

uu

Indicators

u

In

strum

e

nt Pa

nel

Indicator

Name

On/Blinking

Explanation

Message

Safety Support 
Indicator 
(Amber)

●

Comes on when RDM and/or 
CMBS

TM

 shuts itself off.

●

Indicator may come on temporarily when 
passing through an enclosed space, such 
as tunnel.

●

The area around the radar sensor is 
blocked by dirt, mud, etc. Stop your 
vehicle in a safe place and wipe the debris 
off with a soft cloth.

●

Have your vehicle checked by a dealer if 
the indicator does not go off even after 
you have cleaned the radar sensor.

2 Collision Mitigation Braking 

System

TM

 (CMBS

TM

) P. 483

●

Stays on - The temperature inside the 
camera is too high.
Use the climate control system to cool 
down the camera.
The system activates when the 
temperature inside the camera cools 
down.

2 Front Sensor Camera P. 528

101

uu

Indicators

u

In

strum

e

nt Pa

nel

Indicator

Name

On/Blinking

Explanation

Message

Safety Support 
Indicator 
(Amber)

●

Comes on when RDM and/or 
CMBS

TM

 shuts itself off.

●

Stays on - The area around the camera is 
blocked by dirt, mud, etc. Stop your 
vehicle in a safe place and wipe the debris 
off with a soft cloth.

●

Have your vehicle checked by a dealer if 
the indicator and message are still 
displayed even after you have cleaned the 
area around the camera.

2 Front Sensor Camera P. 528

Safety Support 
Indicator 
(Green/Gray)

●

Lights up in green when RDM and 
CMBS

TM

 are on.

●

Lights up in green and gray when 
RDM or CMBS

TM

 are off.

●

Lights up in gray when RDM and 
CMBS

TM

 are off.

2 RDM On and Off P. 519
2 CMBS

TM

 On and Off P. 486

102

uu

Indicators

u

Driver Information Interface Warning and Information Messages

In

strum

e

nt Pa

nel

Driver Information Interface Warning and Information Messages

The following messages appear only on the driver information interface. Press the 

 (home) button, select Warnings to see the message 

again with the system message indicator on. 

2Switching the Display P. 131

Message

Condition

Explanation

●

Appears when the vehicle is no longer able to run 
due to a malfunction.

●

Immediately stop in a safe place.

●

Appears when there is a risk that the vehicle will 
move unexpectedly after you have stopped due to a 
malfunction with the vehicle.

●

While the vehicle is stopped, apply the parking brake.

●

Have your vehicle checked by a dealer.

●

Appears when you set the power mode to ON again 
and the vehicle is able to run.

2 Turning on the Power P. 448

103

uu

Indicators

u

Driver Information Interface Warning and Information Messages

Continued

In

strum

e

nt Pa

nel

Message

Condition

Explanation

• Appears if any door or the trunk is not completely 

closed.

• Appears if any door or the trunk is opened while 

driving. The beeper sounds.

• Disappears when all doors and the trunk are closed.

• Appears when the engine oil pressure is low.

• Appears while driving - Immediately stop in a safe 

place.

2 If the Low Oil Pressure Warning Appears P. 633

●

Appears when the engine coolant temperature is 
near its upper limit.

●

Drive slowly to prevent overheating.

●

Appears when the engine coolant temperature gets 
abnormally high.

2 Overheating P. 631

104

uu

Indicators

u

Driver Information Interface Warning and Information Messages

In

strum

e

nt Pa

nel

Message

Condition

Explanation

●

Appears when the washer fluid is low.

●

Refill the washer fluid.

2 Refilling Window Washer Fluid P. 574

●

Appears when the scheduled maintenance is due 
soon.

●

Consequently, Maintenance Due Now and 
Maintenance Past Due follow.

2 Maintenance Minder Messages on the Driver 

Information Interface P. 557

●

Appears when there is a problem with the sensor on 
the 12-volt battery.

●

Have your vehicle checked by a dealer.

2 Checking the 12-Volt Battery P. 591

●

Appears along with the 12-volt battery charging 
system indicator when the 12-volt battery is not 
charging.

●

Turn off the climate control system and rear defogger to 
reduce electricity consumption.

2 If the 12-Volt Battery Charging System Indicator 

Comes On P. 634

Canadian models

105

uu

Indicators

u

Driver Information Interface Warning and Information Messages

Continued

In

strum

e

nt Pa

nel

Message

Condition

Explanation

●

Appears if there is a problem with the cooling 
system.

●

Drive slowly to prevent overheating and have your 
vehicle checked by a dealer as soon as possible.

●

Appears when the fuel fill cap is loose or is not 
installed.

2 Tighten Fuel Cap Message P. 635

●

Appears if the vehicle’s speed reaches about 10 mph 
(15 km/h) with the fuel fill door opened.

●

Stop the vehicle and close the fuel fill door.

●

Appears when the fuel fill door has been open for 30 
minutes.

●

Turn off the power system, reinstall the fuel cap, and 
close the fuel fill door.
- If you still want to refuel, press the fuel fill door release 

button to reopen the door.

106

uu

Indicators

u

Driver Information Interface Warning and Information Messages

In

strum

e

nt Pa

nel

Message

Condition

Explanation

• Appears if the vehicle is being driven in a manner 

consistent with drowsy or inattentive driving.

2 Driver Attention Monitor P. 144

• Appears if there is a problem with the automatic 

lighting control system.

• Appears while driving - Manually turn the lights on, 

and have your vehicle checked by a dealer.

• Appears if there is a problem with the headlights.

• Appears while driving - The headlights may not be 

on. When conditions allow you to drive safety, have 
your vehicle checked by a dealer as soon as possible.

107

uu

Indicators

u

Driver Information Interface Warning and Information Messages

Continued

In

strum

e

nt Pa

nel

Message

Condition

Explanation

●

Appears when the automatic brake hold system is 
turned off.

2 Automatic Brake Hold P. 536

●

Appears when the automatic brake hold button is 
pressed without wearing the driver’s seat belt.

●

Fasten the driver’s seat belt.

2 Automatic Brake Hold P. 536

●

Appears when the automatic brake hold button is 
pressed without depressing the brake pedal while 
the automatic brake hold is in operation.

●

Press the automatic brake hold button with the brake 
pedal depressed.

2 Automatic Brake Hold P. 536

●

Appears when the parking brake is applied 
automatically while it is in operation.

2 Automatic Brake Hold P. 536
2 Parking Brake P. 531

108

uu

Indicators

u

Driver Information Interface Warning and Information Messages

In

strum

e

nt Pa

nel

Message

Condition

Explanation

●

Appears if the automatic brake hold is automatically 
canceled while it is in operation.

●

Immediately depress the brake pedal.

●

Appears when the electric parking brake switch is 
pressed without depressing the brake pedal while 
the electric parking brake is in operation.

●

Press the electric parking brake switch with the brake 
pedal depressed.

2 Parking Brake P. 531

109

uu

Indicators

u

Driver Information Interface Warning and Information Messages

Continued

In

strum

e

nt Pa

nel

Message

Condition

Explanation

●

Appears when the power mode is in ACCESSORY.

—

●

Appears after the driver’s door is opened when the 
power mode is in ACCESSORY.

●

Change the power mode to VEHICLE OFF.

2 POWER Button P. 190

●

Appears when you close the door with the power 
mode in ON without the remote inside the vehicle.

●

Disappears when you bring the remote back inside the 
vehicle and close the door.

2 Remote Reminder P. 192

●

Appears when the remote battery becomes weak.

2 Replacing the Button Battery P. 593

110

uu

Indicators

u

Driver Information Interface Warning and Information Messages

In

strum

e

nt Pa

nel

Message

Condition

Explanation

●

Appears if the remote battery is too weak to turn on 
the power system or the key is not within operating 
range to turn on the power system.
A beeper sounds six times.

●

Bring the back of the remote into contact with the 
POWER button.

2 If the Remote Battery is Weak P. 626

●

Appears as soon as a problem is detected in the 
smart entry system

*

 or push button starting system.

●

Appears constantly - Have your vehicle checked by a 
dealer.

●

Appears after you set the power mode to 
ACCESSORY or ON.

●

Appears after you unlock and open the driver’s door.

2 Turning on the Power P. 448

• Appears if you press the POWER button while the 

vehicle is moving.

• The message will disappear after six seconds or when 

the power mode is set to VEHICLE OFF.

Canadian models

* Not available on all models