|
|
1E1-10 M162 ENGINE ELECTRICAL Functions 1. Firing order : 1-5-3-6-2-4 2. The ignition cables are located on the cylinder head cover. Each ignition coil provides the high voltage to two spark - T1/1 : cylinder 2 and 5 - T1/2 : cylinder 3 and 4 - T1/3 : cylinder 1 and 6 Removal & Installation Procedure 1. Disconnect the negative battery cable (1). 2. Remove the ignition cable connector from the ignition cable. 3. Disconnect the secondary spark plug connectors from the each spark plugs and remove the ignition cable. Installation Notice 3. The secondary output voltage (5a) is supplied to the No.2 cylinder spark plug through the spark plug connector. The l Make sure that the ignition cables are correctly routed. l Exactly install the ignition cable guide pin into the vehicle to be grounded. 4. Installation should follow the removal procedure in the reverse order. Tightening Torque 5.2 - 8.5 Nm |