|
|
4. Flush the oil cooler and pipes with water and solution for 2 minutes. During this flush, attach the shop air supply 825 kPa (120 psi) to the flushing system feed air valve (2) located 5. Release the trigger (8) and turn the J 35944-A water supply valve (1) to the OFF position. BACK FLUSH 1. Disconnect both hoses from the oil cooler pipes and then connect them to the opposite oil cooler pipe. This will allow the oil cooler and pipes to be back flushed. 2. Repeat steps 3 and 4 of the INITIAL FLUSH procedure. 3. Release the trigger (8) of the J 35944-A and allow water only to rinse the oil cooler and pipes for 1 minute. 4. Turn the J 35944-A water supply valve (1) to the OFF position and turn OFF the water supply at the faucet. 5. Attach the shop air supply to the flushing system feed air valve (2) on the J 35944-A and blow out the water from the oil cooler and pipes. Continue until no water comes out of the FLOW CHECK be captured in a suitable container, preferably with a lid.
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Automatic Transmission - Allison - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
|