|
|
Content .. 2924 2925 2926 2927 ..
to 7.5 volts. Circuit/System Testing 1. Review the scan tool data list mode switch selected and select difference mode with the transfer case shift control switch. Does the mode switch selected parameter on the scan tool 2. If the modes change according to the scan tool replace the transfer case control module, reprogram, complete the motor learn procedure. If the modes on the scan tool not change Repair Procedures Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Transfer Case Shift Control Switch Replacement (Without SLT) or Transfer Case Control Module References for TCSCM replacement, setup, and programming Transfer Case High/Low Clutch Reset NO CORRECTION FOR SLIP IN ALL-WHEEL DRIVE MODE Diagnostic Instructions Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Review Strategy Based Diagnosis for an overview of the diagnostic approach. Diagnostic Procedure Instructions provides an overview of each diagnostic category. Circuit/System Description When transfer case is in auto 4WD mode the transfer case control module monitors the front Reference Information Schematic Reference
2008 Chevrolet Silverado 1500 2008 TRANSMISSION Transfer Case - MP 3023/3024-NQH - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
|