|
|
Content .. 2777 2778 2779 2780 ..
SUNROOF MOTOR/ACTUATOR INITIALIZATION/TEACH PROCESS (EXTENDED CAB NEW Perform the Initialization/Teach Procedure any time a new sunroof motor/actuator is installed in Callout Component Name 1 Sunroof Panel/Window Garnish Molding Assembly 1. Tilt molding approximately 45 degrees with rear end up. 2. Push molding rearward to sandwich headliner and sunroof tub between molding flange and tabs. 3. Grab front of molding at centerline and pull rearward approximately 1 inch. 4. Push front edge up, locking front tabs in place. 5. Push up on outboard edges of molding to secure. 6. After molding is secured, slide the molding forward until it stops.
2008 Chevrolet Silverado 1500 2008 ACCESSORIES & EQUIPMENT Sunroof - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
|