|
|
Content .. 1481 1482 1483 1484 ..
1. Measure the rotating torque of the drive pinion and differential assembly using an inch- pound torque wrench. Specification: The rotating torque of the drive pinion and differential assembly should be 2. If the rotating torque is too low, tighten the differential bearing adjuster nut in 1 slot increments until the specified rotating torque is obtained. 3. If the rotating torque is too high, loosen the differential bearing adjuster nut in 1 slot increments until the specified rotating torque is obtained. 4. If the specification for the rotating torque of the drive pinion and differential assembly cannot be obtained by adjusting the differential bearing adjuster nut, remove the differential
2008 Chevrolet Silverado 1500 2008 Driveline/Axle Rear Drive Axle - Cab & Chassis Sierra, Cab & Chassis Silverado, Sierra & Silverado
|