Audi A4. Body repair manual - part 21
Front door trim
Front door manual window crank installation
position
Illustration shows left manual window crank (right side is mirror of left).
A - Driving direction
Installation position shown: window closed
Front door trim
Release button, adjusting
- When locked, release lever must not project more than dimension -a-.
Dimension -a-: 0-2 mm countersunk
Front door trim
Driver-side power window switches,
removing and installing
- Remove door trim page 70-3 .
- Remove insulation page 70-5 .
- Remove vapor barrier page 70-12 .
- Use screwdriver to remove retaining tabs -1-.
- Remove power window switches -2-.
Front door trim
Passenger-side power window switch,
removing and installing
- Remove door trim page 70-3 .
- Remove insulation page 70-5 .
- Use screwdriver to release retaining tabs -1-.
- Remove power window switches -2-.
Front door trim
Grip handle cover with power window
switch unit and power mirror switch,
removing and installing
- Remove door trim page 70-3 .
- Remove insulation page 70-5 .
- Remove vapor barrier page 70-12 .
- Remove bolts -1- (2x).
Tightening torque: 1.5 Nm (13 in. lb)
- Release retaining tabs -2- (2x) and clips -3- (2x).
- Remove grip handle cover forward.
Front door trim
Vapor barrier, removing
- Remove door trim page 70-3 .
- Remove insulation page 70-5 .
- To install, press in vapor barrier -1- in area of adhesive bead -2-.
- Push power window electrical harness connectors through vapor
barrier.
Front door trim
Power mirror switch, removing and
installing
- Remove door trim page 70-3 .
- Remove grip handle cover page 70-11 .
- Press pins -1- (2x) in direction of arrow.
- Remove retaining tabs -2-.
- Remove power mirror switch -3-.
Front door trim
Door warning light and footwell lights,
removing and installing
- Detach door warning light -1- from below using screwdriver and
remove toward outside together with cable.
- Disconnect door warning light -1-.
- Detach footwell lighting -2- from front using screwdriver and remove
toward outside together with cable.
- Disconnect footwell lighting -2-.
Front door trim
Central door locking switch, removing
- Remove door trim page 70-3 .
- Remove insulation page 70-5 .
- Using screwdriver, detach retaining tabs (2x) and remove central door
locking switch toward rear.
Front door trim
Bass speaker, removing
- Remove door trim page 70-3 .
- Remove insulation page 70-5 .
- Remove bolts -1- (3x).
Tightening torque: 1.5 Nm (13 in. lb)
- Remove bass speaker -2-.
Front door trim
Tweeter, removing and installing
- Remove door trim page 70-3 .
- Remove insulation page 70-5 .
- Pull wiring from door trim up to bass speaker.
- Remove interior door handle page 70-19 .
- Using screwdriver, detach bracket -1-.
- Remove tweeter -2-.
Front door trim
Trim panel in door trim, removing
- Remove door trim page 70-3 .
- Remove insulation page 70-5 .
- Pull vapor barrier -3- down in area of trim.
- Carefully open clips -2- of clips -1-.
- Remove trim panel.
Front door trim
Interior door handle, removing
- Remove door trim page 70-3 .
- Remove tweeter page 70-17 .
- Remove central door locking switch (driver-side
only) page 70-15 .
- Remove bolt -1-.
- Press retaining tabs -2- (2x) and remove interior door handle toward
front.